| Installation
Instructions |
|
Please follow the installation
instructions below:
-
Determine where
you are going to mount the two (2) lights on your vehicle.
-
Route wires
from mounting location on your vehicle to wire or socket connection.
-
Locate positive
wire to Brake lights.
-
RED WIRE on
Life Brite Products is the POSITIVE WIRE. Connect red wire to positive wire
or to connector junction (socket terminal) of your motorcycle
-
BLACK WIRE on
Life Brite products is the GROUND WIRE. Connect black wire to any ground on
your vehicle.
-
Ensure good
electrical contact. Wire splicing can be done if necessary to accommodate
installation. Use electrical tape or heat shrink at wire splice.
-
Clean surface
before mounting lights. Lights must point straight and tilted up slightly
for maximum visibility.
|
Available
T-brackets make it possible
to mount Life Brite lights to your bike. |
 |
NOTE: If you are not able
to, or do not have time to install your new lights, vehicle service centers or
auto electrical shops can install them for you. They will normally charge you
their hourly shop rate.
|
